The failure pressure of pipe with wall-thinning was investigated by using three-dimensional elastic-plastic finite element analyses (FEA). With careful modeling of the pipe and flaw geometry in addition to a proper stress-strain relation of the material, FEA could estimate the precise burst pressure obtained by the tests. FEA was conducted by assuming three kinds of materials: line pipe steel, ...

CRA-lined pipelines, i.e. pipes with an inner pipe of a corrosion resistant alloy inside of a ferritic steel pipe carrying the hoop stress, pose a challenge to inspect with conventional in-line inspection technologies. Existing UT technology is not able to inspect through the interface of a CRA and a ferritic steel component. Additionally, current MFL technology is not able to sufficiently magn...

The wind turbine foundation serves as a permanent construction in the harsh marine corrosive environment, its anticorrosion design is essential to the safe use of the wind turbine structure. At present, there is a significant controversy over the local corrosion mechanism (such as pitting corrosion, and crevice corrosion) and its diffusion mechanism in the academic circle. In the paper, the Far...

The deformation and fracture of the high strength steel which is used to fabricate grade X100 steel pipe were investigated at room temperature, on plate and pipe. Anisotropic behaviour was characterized by using tensile tests conducted along different directions. The fracture toughness of plate and pipe materials are compared using compact tension (CT) and Charpy V-notched tests. In both cases,...

On-line spray water cooling (OSWC) of electric-resistance-welded (ERW) steel pipes can replace the conventional off-line heat treatment process and become an important and critical procedure. The OSWC process improves production efficiency, decreases costs, and enhances the mechanical properties of ERW steel pipe, especially the impact properties of the weld joint. In this paper, an annular OSW...

Original scientific paper Stress measurement by using ultrasonic waves is based on acoustoelasticity law, i. e. the relation between stress and wave velocity in engineering materials. Longitudinal critically refracted (LCR) wave is a popular ultrasonic wave in the ultrasonic stress measurement application. The LCR wave is a bulk longitudinal wave that travels within an effective depth underneat...

In order to study pressed pile test and ultimate bearing capacity character of large-diameter steel pipe pile, based on two high-piled wharfs of Zhanjiang Port, pressed pile test and numerical simulation of three large-diameter steel pipe piles are analyzed in this paper. Anchored pile method is used to pressed pile test, and the curves of Q-s and ultimate bearing capacity are attained. Then th...

This paper proposes, for low buildings, an integrated wall structure of a brick-stem-insulating layer, which plays a major part in both heat preservation and force bearing. The research team has tested the thermal performance of the structure, the results of which are satisfying. To further study the force-bearing performance, the paper carries out compressive tests of specimens of different st...

In the present study, heat transfer and entropy analysis for flow through a pipe system is considered. The Reynolds number and the pipe wall temperature effects on entropy distribution and total entropy generation in the pipe are investigated. Numerical scheme employing a control volume approach is introduced when solving the governing equations. Steel is selected as pipe material, while water ...

Transmission loss measurements are reported for long steel pipes of circular crosssection, with air inside and out, excited by internal sound. At low frequencies (wavelength greater than the pipe diameter), most of the radiated sound is accounted for by pipe bending waves. In order to approach the much higher transmission loss predicted for pure breathing motion of the pipe, bending waves must ...